Engine Start and 18 Point Check 

Crowley's 18 point engine check is the best way to minimize last minute surprises and start your season with confidence. After launching, our marine certified mechanics will start your engine and perform an 18 point check of your engine and related systems. Included is a visual inspection of the engine, fluid levels, hoses, belts, wires, cables, shafts, alternator output and other systems. A written report is left on your boat for your records. In most cases, an engine start is required when other engine work is ordered. Minor repairs are made if time permits. Otherwise, we will note the discovery on the engine start report and suggest you schedule a harbor call after the spring rush. If a significant problem is discovered during the engine start, we will contact you to discuss your options.

Gas Engine Tune-Up  

New plugs, wires, caps and rotors are installed to ensure that the ignition system operates properly. The carburator and timing is adjusted as necessary to aid in quick starts and full power throughout the operating range. The work is completed in addition to the engine start.

Shaft Alignment

Our shaft alignment is the key to smooth powering. Not only is the system adjusted, but other sources of vibration are checked and recommendations are made if needed. If you experienced excessive vibration last year while under power, you are a candidate for this service.

Repack Stuffing Box

We recommend this service every few years. We repack the stuffing box (where the shaft comes through the hull) before the boat goes in the water. After the boat is launched, a mechanic will run the engine and make adjustments.

Sterndrive Service  

Regular maintanence of your sterndrive will help prevent the need for costly drive replacement. Our mechanics will remove your sterndrive and inspect the bellows, boots, shift cable, input shaft and coupler. We will lubricate the input shaft and coupler and change the upper and lower unit oil. After the inspection, lubrication and oil change the drive is reinstalled with a fresh seal kit. Trim operation and fluid levels are checked along with engine alignment.

Zinc Replacement and Installation  

Anti-corrosion zincs protect valuable metal components from corrosion. Stray electrical current and galvanic corrosion do irreparable damage to your propellers, shafts, struts, rudders, drives and other components. The inexpensive anodes attract galvanic currents and corrode instead of valuable metal items. The anodes can usually be replaced in less than one hour.

If you have any questions, please contact Customer Service at 773-221-9990.